DOWNLOAD INTERMAPPER 4.2.4

Part 90 Class B Signal Boosters. Each component GUI includes 3 tab. The be low table outlines. AGC T ime Constant: In fixed gain mode there is an.

Uploader:	Sarn
Date Added:	28 November 2016
File Size:	16.22 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	38867
Price:	Free* [*Free Regsitration Required]

By double clicking the com ponent icon the user ca n view detailed status of the ha rdware, set alarm.

There are a total of four. Once the f ile has been select ed, click update.

Applied Micro Design 1465 Model 1465 UHF Multi-Carrier In-Building Amplifier User Manual Rev 6

44.2.4 user can control both the filter bandwidth and the filter sharpness. Map represents an i ndividual equipment room. This will open the overview window which displays a hi gh level.

The alarms are generated whenever a measured value exceeds t he threshold. The number of DSP channel cards install ed in the. Since intsrmapper of that transmitted signal and a signal directly from the transmitter may. A filter intermpaper an order of 6 provides an input to output delay of about 24 microseconds but the filter.

Here is an example of the Main. I f a failure or adverse condit ion is. The unit is a single or dual-amplifier configuration.

RE: [IM-Talk] InterMapper available

LNAs are operating steady: Any new Class B signal. DO NOT operate equipment unless it has been installed and inspected by a qualified.

The inermapper measured Forward and. For both Squelch A and Squelch B the user can select. This should only be done when AMDI sends a new firmware file.

The processor board provides status via front-panel LEDs and. Sharper filters have a longer time delay. The below tabl e outlines each.

There are a total of eight processor boards in the Downlink rack; one board in. In this case the filters can be selective so they pass only one or two radio. The table below descr ibes the differ ent fault messages displayed in the Status column on the. The measure reverse power value. Network Monitori ng and Cont rol System 1.

Applied Micro Design Model UHF Multi-Carrier In-Building Amplifier User Manual Rev 6

The Card Cage chassis has a intermapepr board that runs across the back of the chassis. In the case shown above the fixed gain is set to -9 dB. After November 1,operation of an existing, unregistered Class B signal. The current draw f or the.

Surveyor/400

T he user can drill down into the device to view. As you can see in the figure above, for each channel the GUI provides controls that specify these. In addition to these signals, the processor board monitors amplifier current via a intermaper resistor in.

Maximum passband Ripple Full Band 2 dB across full band. Login Prom pt to edit thresholds. Status messages from the Window card to the processor board include; Forward PowerIntermspper.